Hi Ms. Lori--

I recently purchased a Lori's Device #1 for PA piercing, and I am really happy with it. 

I have been locked in it 24/7 for about 10 days (so far this time) and have not been told when I will be released other than that it will be awhile
(maybe a few months).   This is, without doubt, the best device I have found, and my keyholder is very impressed with it as well. 

I am difficult to fit with a CD for a variety of reasons--I am a grow-er, I have not been able to tolerate testie rings for more than a few days despite
a variety of attempts at polishing/lubes/etc., and I am a big person. 

I have tried a wide variety of devices, including most of the plastic devices, a German belted cage, and two of your devices.  I have only been
able to tolerate two of them for long-term (more than a few days) continuous wear--your #1 and a homemade polycarbonate tube that was also secured to the
piercing.  My #1, even with spikes, is actually more comfortable to wear than the tube.  Being more open to the air, I think it is also healthier for
the skin. 

The relatively open tube is easy to clean (on and off) and it's quite a bit lighter than the solid tubes.  My earlier Lori's tubes were frankly a bit
heavy to be supported mostly by the pin in the piercing.  So far, that hasn't been a problem with the #1, though I believe that having a large
gauge, well-healed piercing is very important. 

The stainless steel construction is impressive and is holding up very well.

The device doesn't show even with fairly tight trousers. 

I really like the hinged hood.  It makes the device very easy to put on and to take off while being every bit as effective as the regular fixed hoods.
The tip of the piercing pin goes through a hole in the hood, so you cannot push the tube down far enough to free the pin from the piercing like I was
able to do with an earlier tube. 

The security screw locking system is very simple and very secure.  The head is recessed into the device, and it cannot be removed with pliers.  The hole
for the special screwdriver bit is very small and doesn't lend itself to manipulation.  I have a large selection of screwdriver bits, but none of
them work with this screw.  I suppose it could be drilled out, but even that seems risky given where it is worn.  Drilling would also be very obvious to
the keyholder. 

Providing the special blades as screwdriver bits and including a handle is a very nice touch.  The bits fit nicely into a locking key box.

I don't see any way to get this thing off without either using the provided screwdriver bits or causing some serious damage to the device, my anatomy,
or both.

It is VERY effective at preventing any sexual activity.  I think I am going to be VERY frustrated by the time I get out of this thing. (Do I hear
someone saying something about being careful what you wish for?)

I ordered mine with spikes.  I probably won't order them on future devices. They don't hurt me enough to prevent an erection, but I think they might
have the potential for abrading the skin over a longer wearing.

You have been described as being on a mission to get as many men permanently locked up as possible.  This is one device that should really contribute to
accomplishing such a mission.  Thank you for a VERY good CD.


Thank you,

JB

                                                                                                       HOME